20% OFF. BLACK FRIDAY DEAL. CODE: BF20

Single-Beam vs. Dual-Beam Timing Gates for Sprints

Compare single-beam and dual-beam timing gates for sprints. Learn what triggers each system and which questions to ask before buying.

Motion Trials

11/21/20261 min read

Motion Trials Sprint timing sensor in use
Motion Trials Sprint timing sensor in use

Single-beam timing gates use one light beam at a timing point. Dual-beam gates use two beams, often at different heights, and the system applies a trigger rule to them. For sprint testing, ask what movement starts or stops the clock and how consistently the setup records it.

How does beam configuration change the trigger?

A single beam can be interrupted by whichever body part reaches it first. A leg or swinging arm can trigger some setups ahead of the torso. A dual-beam design can reduce some early triggers when its logic requires both beams to be interrupted. Beam heights and trigger rules vary by system.

  • Check the trigger. Ask which beam events count and how the system handles a brief obstruction.

  • Check the height. Test the intended setup with athletes whose stature and running posture reflect your group.

  • Check the output. Confirm that staff can recognise a missed or unexpected result during the session.

What does a comparison study tell us?

Haugen and colleagues compared single- and dual-beam photocells on the same 40 m runs. In that setup, the reported time differences were around ±0.05 to 0.06 s. Use this as a reason to document your equipment and protocol. A universal conversion between systems would require evidence that it holds for the setup you use. Read the photocell comparison study.

How should you compare an ultrasonic sprint timer?

Motion Trials Sprint uses ground-standing ultrasonic sensors. Coaches can set up a lane without light-beam reflectors, tripods or wearable tags. To compare it with photocells, measure the same runs over the same section and record the start rule and both systems’ detection settings. Check the Motion Trials sensor specifications and compare optical and ultrasonic timing.

Common questions

Do dual-beam gates always give a later time?

The direction of the difference depends on where the start and finish events occur. An earlier or later trigger at either end can change the interval in different ways.

Can changing gate height affect a retest?

Yes. Beam height can change which part of the runner triggers the gate. Record the configuration and reproduce it for follow-up tests.

Designed and assembled in the EU.

© 2026, Motion Trials

¹ Products are processed and dispatched from the EU. Delivery is free on orders over €50 within the European Union. Import duties, local taxes, or handling fees may apply depending on your country's customs regulations and must be paid by the customer. Prior to ordering, please check your local customs requirements or contact our support team at support@motiontrials.com