20% OFF. BLACK FRIDAY DEAL. CODE: BF20
How Do You Time 60 m Sprint Splits With Timing Gates?
Set up timing points at 0, 20, 40 and 60 metres. Work out individual split times from one run and compare the same sections at retest.
Motion Trials
11/21/20262 min read


To time 60 m sprint splits, put timing points at 0, 20, 40 and 60 m. Record the cumulative time at each point, then subtract consecutive readings to get three 20 m segments. Keep the same start rule each time you test.
Where should the timing points go?
Lane: fixed athlete start mark → 0 m timing point → 20 m split → 40 m split → 60 m finish → clear run-out.
Measure the timed section. Mark each detection point along a straight lane. Check that the runway beyond the finish is clear.
Define the start. For gate-to-gate timing, place the athlete at a fixed mark behind the first sensor. Record the offset, start stance and instruction.
Rehearse the full run. Check that your system registers all four points in order. Agree on how you will flag an attempt with a missing split.
How do you calculate the three splits?
Suppose one athlete reaches 20 m in 3.10 s, 40 m in 5.50 s and 60 m in 7.95 s. Those readings are all measured from the first timing point.
0–20 m: 3.10 s.
20–40 m: 5.50 − 3.10 = 2.40 s.
40–60 m: 7.95 − 5.50 = 2.45 s.
The 20–40 m segment was the fastest of the three. It averaged 30.0 km/h because 20 ÷ 2.40 × 3.6 = 30. Check several comparable runs before treating the 0.05 s difference between the last two segments as a pattern.
Which Motion Trials kit works for this setup?
Motion Trials Sprint Pro includes start and finish sensors and two split sensors. A four-point sprint timer gives you the finish time and both intermediate readings in the same run. For a shorter setup with one intermediate point, see the 0–10–20 m split guide.
Common questions
Can two sensors record the whole 60 m?
Yes. Place one at each end of the timed section. Add intermediate timing points when you need segment times from the same run.
Can I compare this with a race time?
Label the gate-to-gate result as a training measure. The clock starts at the first crossing. An official gun-to-finish race time starts at the signal and includes the athlete’s reaction.
Designed and assembled in the EU.
© 2026, Motion Trials
¹ Products are processed and dispatched from the EU. Delivery is free on orders over €50 within the European Union. Import duties, local taxes, or handling fees may apply depending on your country's customs regulations and must be paid by the customer. Prior to ordering, please check your local customs requirements or contact our support team at support@motiontrials.com